Why not decorate around your burner?

Decorate around and behind your bio-ethanol burner with these 2 brushed stainless steel plates and its protective glass.

To do so:

1. Fix the curved plate vertically to the back of the burner.
2. Screw on the clamp fasteners of the protective glass
3. Place the other plate over the space you have reserved for the burner
4. Place the burner in the slot
5. (Finally) Fit the protective glass

And that's it!

4 available widths

There are 4 plate widths available:

• A 100cm wide plate for an 80cm burner
• A 120cm wide plate for a 100cm burner
• A 140cm wide plate for a 120cm burner
• A 150cm wide plate for a 140cm burner

The plate around the burner is 25cm deep, whatever the width.

The curved plate behind the burner is 58cm high, whatever the width.

The plates are supplied with :

• A tempered glass pane
• 2 clamp fasteners for the pane
• 6 screws to fix the curved plate at the back

Please note: The 2 plates (the curved plate + the plate surrounding the burner) are not welded together; you can fit them independently of each other.

IMPORTANT:The burner corresponding to the plate is not supplied. It is sold separately.